WHY THE SYNCHRORONOUS MOTOR IS NOT SELF STARTING, AND WHY
THE STATOR AND ROTOR IS COUPLED?
Answer Posted / guest
when 3ph wdg is supplied with 3ph supply, a magnetic flux of
const magnetic field rotating at syn speed is produced at
stator.
at first half cycle(a period of 10 ms)N pole of rotor and N
pole of stator are repelled each other as well as S pole of
rotor and S pole of stator.in the next half cycle(a period
of 10 ms)poles of stator interchanged ie., N pole of rotor
and S pole of stator are attracted each other as well as S
pole of rotor and N pole of stator.
due to continuous and rapid rotation of stator poles, the
rotor is subjected to a torque which rapidly reversing.
because of its large inertia rotor cannot respond to such
reversing torque results remains stationary.hence
SYNCHRORONOUS MOTOR IS NOT SELF STARTING
Is This Answer Correct ? | 8 Yes | 2 No |
Post New Answer View All Answers
What is the role of feedback in a closed loop control system?
can we synchronize star system generators with delta system transmission line ? and how ?
Give the expression for the frequency of oscillations in an op-amp sine wave oscillator?
What are steps to be taken while designing of DYN11 distribution transformer to achieve magnetising balance?
Dear Respected sir how to test ABB REX521 protection relay by relay tester.
how to revers the direction of single phase motor
Installation resistance for whole installation of 16 kva & 25 KVA DTRA a) Between each conductor b) between conductor to earth c) installation resistance for each apparatus, each conductor to earth d) earth resistance for the system of earthing
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
Write the analogous electrical elements in force current analogy for the elements of mechanical translational system.
what is PID control in VFD drives?
explain remenance . differentiate high remenance type ct & low remenance type ct
What is the difference between alternator and generator?
What are the necessary solutions needed to be carried out on a malfunctioned earthing mechanism of a VACUUM CIRCUIT BREAKER.(TAMCO)
Can we use shunt trip coil instead of trip coil with protection relay for protection?
how we can calculate power factor in single phase & three phase ?thank u