Interested to Buy Any Domain ? << Click Here >> for more details...
how to choose the cable rating for load (KW)? EXAMPLE.50KW load
- 14 Answers
- 172147 Views
- ACC, NCUI, Polycab, PowerSol, Siemens, SW, I also Faced
- E-Mail Answers
Answer Posted / shabeeb
50kw load will take 87 amps (approx.). There is table of
different types of cables available in the manufactures
site. More over there is so many factors are there to
select a cable. Such as the type of material (copper /
aluminium), single core or multicore, how and where the
cable is being laid, the length of cable(for voltage drop
calculation), type of load and its starting current (for
motors), future load etc. Normally if the load is 50KW,
70sq.mm Aluminium cable or 50sq.mm copper cable can be used.
| Is This Answer Correct ? | 29 Yes | 16 No |
Post New Answer View All Answers
can a 150 kva 3 phase 440v/230V delta-wye step down transformer can be use as step up transfoermer with connected loads at 440v side?
How do i carry out or know the vector group of a Dyn1 and Dyn5 transformer
What is the difference between the impedance percent and impedance voltage ?
whati s the sludge current in ups
While HT line put on to activate ACB in low tention panel VCB tripping instantly.why it happens
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
How does an induction motor start?
TCS IS IT COMPANY THEN WHY DO THEY NEED ELECTRICAL &ELECTRONICS ENGINEERS?
what is the use of vcb & isolator in substation?
Why space heater is required for each verical bus bar chamber? if one space heater is adequate or not for anti condensation?
how to calculate the distance relay faulty zone?pls explain?
if grounding is notdone at regular intervals for long distance transmission, will the load connected at distribution end receive voltage during negativehalf cycle of the sine wave?
What is the unit of magnetic flux density?
What is the function of retrip in busbar?
A 3-PHASE TRANSFORMER IS USED TO STEP-DOWN THE VOLTAGE OF A 3-PHASE, 11KV FEEDER LINE. PER-PHASE TURNS RATIO IS 12.FOR A PRIMARY LINE CURRENT OF 20A, CALCULATE THE SECOUNDRY LINE VOLTAGE, LINE CURRENT AND OUTPUT KVA FOR FOLLOWING.A)STAR- DELTA.B)DELTA-DELTA.
