Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / afsal.a
comparing the response of an instrument with standard
instrument is called calibration
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
hiii.... can any one provide me previous years question paper of hindustan petroleum for instrumentation engineering???
What are the type of bonnets in the control valves?
Draw a simple circuit for a well head control panel used to protect the well against fire, leak, blockage, ESD, & controls the operation of one downhole & one surface safety valve. Explain the operation and controls
A flange is used for instrument connection for a system with a design temperature of 316C (600F) and a design pressure of 1000 kPa (145 psi). What is the class rating of the flange to be used for this application? Explain your answer
What is 3 selection available when configure the burnout protection for controller
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
Explain the burnout feature.
What is the difference between mmwc and mmwg?
when placing a vent or drain hole on an orifice plate should you measure from the center of the bore up or down for the vent placement?
Good evening all I need a small favour regarding reliance paper i wanna probable sample papers(e&i) of reliance. if any of u have any idea about dis then plz mail me back.i belongs to electronics and instrumentation engg.so i need e&i papers. thanking u....
how to calibrate steam control valve in steam turbine
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
What are the interlocks we have to check during the start up of LP/HP compressor?
-/5A. What is the meaning and limitations of this in energy meter constant. It is a 3 phase LT Energy Meter. If this Energy Meter is connected through a CT of ratio 200/5 Amps, then what is the multiplying constant and how its will be calculated.
What is heating effect?
