Is 3C x 2.5 Sqmm Cable can withstand 40Amp Starting current?
If Yes then specify your ans.
Answer Posted / pkb
continuous current rating of 2.5 sqmm copper cable is
19Amp. This can withstand 40Amp starting current as it
remains for few seconds.
Is This Answer Correct ? | 6 Yes | 2 No |
Post New Answer View All Answers
PAC and simple Ac different
why the rotor current becomes in steady state during high slip region? please verify with equations.
how give earthing conection to household equipment?
In control room of our one plant there is a continuously the incoming power goes to PC is vary,means in stabilizer it continuously indicate from high input to low and low input to high. what is the reason and its solution.
Please brief working principle & construction of permanent magnet AC Servo motor
what is mean by NPS (Negative phase sequence)fault? what is the difference between EFR & OCR faults?
WHAT IS MEANT BY TV TERMINAL IN 500MVA TRANSFORMER?
PLEASE TELL ME ABOUT QUESTION PAPER OF UPCL ENTERENCE EXAM.
i want to learn control schedule for 11kv panel? can any one send the detailed control schedule?
WHat is the requirement of installing FAST ACTING EARTH SWITCH in GIS and how is that integrated with protection system. How and when does it operate?
WHY L-G FAULT IS MORE SEVERE IN TERMS OF RRRV?
do we use links in a dc circuit?if so what s its use in it?
what should be correct gas pressures to be a 1.5 ac unite
in wind mill use 2100 kw asychronous generator ( induction generator ) rotor voltage : 3300,stator voltage : 690, rpm : 1511 type : MRL063E04 ' we check rotor resistance magger value found following. R-EARTH - 00 M.OHM,Y-EARTH-34 M.OHM,B-EARTH- 33M.OHM R-Y: 31 M.OHM, Y-B: 00 M.OHM,B-R :33 M.OHM HOW CAN I TAKE DECISION?pls ans. quickly
Hi Friend I am used multimeter to measure the voltage between R Phase(SS1) to R Phase(SS2). In SS1 is connected with UPS loads. But I am getting voltage between these 2 R Phases. Please give some idea friend