Interested to Buy Any Domain ? << Click Here >> for more details...
can induction motor run over the rated speed ?
- 12 Answers
- 18289 Views
- ACC, I also Faced
- E-Mail Answers
Answer Posted / alacoque jean
Yes, by flux control.
Rated speed is the maximum motor speed at full torque (full load).
To increase the motor speed beyong the rated speed, one must decrease the motor flux module, with a constant feeding voltage and a maximum decreasing torque in inverse ratio of the speed.
This can be made with inverter and voltage vector control as "Field Oriented Control".
The feeding frequency increase.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
why are installed water leakage detection system data centers & server rooms
what is the formula for efficiency of francis turbine and generator for hydropower? what is best way to select francis turbine and generator?
what is the meaning of 0.5ohm Resistance
The efficiency of a 100kva transformer is 0.98 at full load as well as half load , for this transformer what is the Copper loss at full load ?
how the characterstics of control valve being done
we can run 2phase as 3phase .what will be the differnce with respect to phase angle, power, current between the two modes
Why field rheostat is kept in minimum position while armature rheostat at maximum position?
What is the resistance of the field winding of a d.c. Shunt generator kept low?
1)What is a Triode? What are its uses? 2) What is a Triac? 3) What is a Thyristor?
what is high - pot test. what's its use?????
What is electrical grounding?
1. The DC generaror,s induced output emf is connected with a DC motor(as load). when increasing the load of the motor by using brake drum or any way. what are the parameters will changes in both motor and generator(voltage, current, resistance, frequency, speed, torque, power, flux etc...) 2. Similarly for AC generator and AC motor 3. similarly if using DC batteries instead of DC generator, What happens?
63MVA,220KV/6.9KV Transformer LV side neutral is connected to Earth pit through NGR. Whether this earth pit required to connect with near by below grouding earth mat or it is to be kept separate?
2. A current i=(10+10 sin t)amperes is passed through MI type ammeter. its reading will be.........
how we decide the require size is this for a known current at fuu load?
