Answer Posted / b.sudhakaran
A Check & B check for DG set, A check means daily check for dg Like diesel level,oil level, radiator water level, Dg room cleaning, air filter checking, and all value position ( open or close condition check above state.now you switch on primary motor for 5mints( for oil lubrication purpose) now you can switch DG for 5mints this is for A check, B check means 300 hours for dg or every 6month that time replace oil,oil filter, diesel filter and check air filter pulse A check this is b check.
Is This Answer Correct ? | 3 Yes | 1 No |
Post New Answer View All Answers
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in
In radial network the source is fed from 1 end both ends at central
how to check ac servo motor
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
how technical is calculated in 11kv line and lt line
what is auto re-closer?
How does an induction motor start?
How to megger test 11 kV cable and the acceptance IR value
Difference between low impedance and high impedance Restricted Earth Fault
what is the question paper model for section engineer in RRB
what happen if the parallel generator phase angle shift by 1 degree in manual mode
What is the difference between electronic regulator and ordinary rheostat regulator for fans?
Dyn1 transformer vector group testing how to do