Interested to Buy Any Domain ? << Click Here >> for more details...
I have 90KW Motor 60 Hz,380V Pf 0,88.
after testing the Motor without Load is the no load Current
36 A,but wenn i put load after 2 hours the current increase
more than 156 A.
Can anybode tell me waht is the Problem?
- 4 Answers
- 7362 Views
- ABB, I also Faced
- E-Mail Answers
Answer Posted / linu mohan
motor full load current is 155-162A for different categories
of make;so check from which load the motor is connected
ex-compressor,pump or crusher likewise anything
1)compressor- air might have blocked in the filter due to
impurities in the air after few hrs,so motor taking high
current.
2)pump-jamming might have blocked in the filter due to
impurities in the water after few hrs,so motor taking high
current.
if the motor is kept in a closed atmospheric room then due
to heatness after few hrs motor will take full load current
&tripping occurs,so to avoid that; place an exhaust in there.
last option clear that its not a star delta feeder...
if then also problem is not solved&strikes again then it
comes under mechanical head for sure
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is the name of transformers oil filteration equipment?
Explain what is electric traction? Explain few advantages of electric traction system?
How we can change the direction of rotation of Induction motor? Prove it using graphical
What range of speed can you get with the armature control method of speed control of d.c. Shunt motor?
What is the difference between electrical earthing and electrical grounding?
what is the difference between switchgear and circuit breakers and is there any difference between outdoor and indoor switchgear and circuit breakers , and how would you differentiate between switch yard and substation and grid station . thanks
what is the stear deltaprinceple?
In three pin plug 6 amp. 220V ac rating. Why earth pin diameter is higher than other two pin? What its purpose ?
Usage of flywheel diode in relays
sir please send me previous year questions of jspl of electrical section through which i could prepare myself fpr the test.
What is the difference between single point and double point bonding. please kindly detail about bonding of cables.
how is working bearing heater?
Difference between ac parallel circuit and ac series circuit?
I would like to know that the fault curretn at base load and at 10% generation will be same? Fault level of BUS remain same with different generation?
What should be the protection scheme for a 15kw, 3-phase motor working in a lathe machine.
