How to select Main CB Rating for 220 KW Load?
Answer Posted / velusamy
Select based upon current rating
next 220kw using voltage
For Ex:
220kw
415v
means it will take arround 350 Amps so we can select the CB
more than the current with withstand capacity
Is This Answer Correct ? | 8 Yes | 6 No |
Post New Answer View All Answers
what is the current density of copper & alluminium.
If I want to lift the water at a height 50m from ground level through two inch(diameter) metal pipe then what is the capacity of motor pump is required? is it possible in single phase supply or not?
in 132kv substation CRT means
I am interested to know what does 15 KVA DG set actually means? If I dont know the DG rating, is it possible to identify KW by simply knowing the diesel consumption?
11kv/433v delta/star distribution transformer primary side full load Ht current is 83.33A in , but input side VCB rating 800A.why?
how is find out kwh step by step
In what cases (circumstances)we should apply P controller, PD controller, PI controller & PID controller ?
at work we have a 3 phase motor but on testing one phase isnt getting a reading. it runs 24 hours a day all week. stops and starts well no noise or heating. the phase isnt down to earth.is it just a bad meter reading or not? phases one and three came up with a resistance reading of 0.4 but phase 2 couldnt get anything shows up as open circuit.
Draw the vector diagramme for Asynchronous Induction Generator at noload,half load and fullload.
Can I use star delta connected induction motor for dual supply voltage?
any one can explain what is the size of pvc,armoured, various sizes of powr cable dia?
i am going to give the JSEB,RANCHI exam for power plant,so i need some samples of papers related to that,so please send me these papers by my mail id.
WHY IN AC DRIVES,INPUT PHASE CURRENT SHOW UNBALANCE?
what are the applications of transistors with low dc gain, high dc gain and medium dc gain( beta)?
what is the effect of connecting three phase supply lines to three phase auto transformer output terminals through a fuse of 10Amp and a circuit breaker (MCB). Is this connection permanently destroy the transformer?