Interested to Buy Any Domain ? << Click Here >> for more details...
Why we should use delta connection in primary and star
connection in an distribution transformer, which converts
400v a.c. voltage to 33kv.
- 15 Answers
- 49174 Views
- ABC, Kirloskar, Sify, I also Faced
- E-Mail Answers
Answer Posted / ravishankar.m
Generally we recevied power supply from HT.In HT side there
will be not available neutral source so in primery side we
given delta connection.But in secondary side we must need
nuetral for three phase & single phase equipments so we
will create from oueself (create from earthings) so here
the connection must be a star connection.
| Is This Answer Correct ? | 0 Yes | 2 No |
Post New Answer View All Answers
if negative of DC supply used and positive is grounded through EGB, and if ELCB used in the system then is it sense the positive volatge and get tripped is it possible?
What is the tipical Online UPS input voltage for 20 KVA load ( 3 Phase or 1 Phase )? Why ? Explain it...?
3phase cable calculation formula by motor load
Initially, when the input is not equal to the output — what type of response is this?
which VFD is better ( LT or HT)
What is meant by celling voltage & current in excitor ?
what are all types of cross section in AC cables?
Is there any relevant technique to produce power from light and heat energy of the sun simultaneosly from same rays of light?
what is the use of surge suppresser in 33 KV incoming panel. where it must be installed,inseries with incoming cable surge suppresser must be at incoming of the breaker are outgoing of the breaker
The magnitude of sum of two sinusoidal av voltage is equal to 230 volt.the magnitude of each individual voltage is also equal to 230 volt.what must be the phase difference between voltages?
if 6 earth pit value is 1.5 ohm then what should be the number of earth pit to make the value .8 ohm
what are the factors to be considered while design the breaker either HT or LT??
my diploma certificate in my higher education college
how we calculate the dick for a pole?
Do u know any one? how to find out in motor rated amps? formula?
