Interested to Buy Any Domain ? << Click Here >> for more details...
Why is the earth fault relay connected to the Yellow
Phase?
- 4 Answers
- 10143 Views
- I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
In my answer No.2 pl read as 2OCR and 1 EFR
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)
what is the IEC standard for Power Cable installation in onshore (like in direct buried ground or above groung)
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What types of CMOS memories have you designed? What were their size? Speed? Configuration Process technology?
Which device of PlC does share load between DG sets when DG are running in perallel?
ACCORDING TO IEC WHAT SHOULD BE THE MINIMUM HEIGHT OF G.I. STRUCTURE OF CT, PT, ISOLATOR, LA?
If we use 250A MCCB as a incomer in Control panel for a fault level of 50kA for one second ,assuming temperature rise from 85 Deg. to 100 Deg , Then what will be the Aluminium Bus-bar size for 250A MCCB? Explain in detail.
what is the standard duration after failure EB power
PLZ EXPLAIN CORONA,SKIN,BIRD PALE,SPAN,SAG Effects of power cable.
A cable with concentric PE conductor must be used with frequency converter circuits what does its means.?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
What are the causes of unbalanced current on 34.5kv feeder Ia=0.05,Ib= 0.25, Ic=0.15 and In=0.27 prior to tripping current are balance?
l&t switch FN 63 handle position can we change
is there any device that works properly accept relay, it may be fuse but if i want fuse of 33kv 300 amp it is avaliable, pls give me details
Usually in the L & T make MCC feeders' power circuit,we have BMR after the MAIN CONTACTOR.,can we interchange their position, keeping the control logic same???
