Interested to Buy Any Domain ? << Click Here >> for more details...
transformer core are laminated for what purpose?
- 9 Answers
- 39805 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / ashish tekade
In order to reduce eddy current losses
| Is This Answer Correct ? | 13 Yes | 5 No |
Post New Answer View All Answers
why T/F winding temp measurement cts are odd secondary current ie,109A/1.2A/1.4A?
When are the directional relays used?
what is reverse power relay brief explanation and in b/w where it is connected
Earth bits close or open. Which is correct
explain the function of brush less dc motor?
Why we use auxillary relay ? what is function of differential relay, directional o/c relay?
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
How to know the following data of synchronous generator 1. D-Axis Unsaturated Reactance 2. D-Axis Unsaturated Transient Reactance 3. D-Axis Unsaturated Sub - Transient Reactance
At full load wat is the motor p.f And at no load will is the motor p.f?
A 2083kva AVR was tested, phase to ground shows continuity, what is the implications
This is reqd for a 1MW Solar power plant..We have 2DC outputs from the solar panels Connected to 2INVERTOR panels.. Output from invertor is 3ph,280v,500kva,50hz.These are connected to individual ACB.This has to be stepped up to 11KV ,1250KVA SYSTEM.Now can I use (1) one more ACBTO GIVE A COMBINED OUTPUT OF 1000KVA,280V & STEP UP THE OUTPUT BY USING a single two winding 3 ph transformer 11kv/1250kva. or (2)use the two outputs and connect to one three winding transformer of above rating..Pls suggestwith details.
I need to connect a synchronous generator to the grid using automatic synchronization and two circuit breakers (one for synchronization, one for end connection to the grid), how to determinate the required diameter of the cables?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
what type of earthing do for dry fissure rock?
what are safety measures in /control in diesal engine/ explain them?
