Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / bipin
it is 1-phase...25kv ac, 50Hz. actually traction substations
are there which recieve 3 phase supply and divide these
phases into sections of about 30-40 kms along the line. each
of these sections are completely electrically isolated from
each other by using dead sections.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
how to find out cable size if load is 2800 watts, 230 volts AC supply and load distance is 1800 meters
how to calculate the conductor size for certain KV transmission line and distribution line?
what purpose to use excaiter in DG.?
what is the defination of Cable database? What are the points are considered while preparing cable database? Is there any sample available for cable database?
As we use capacitior bank in 3ph ckt for improvement of PF, why not we use capacitor in single phase domestric use, at our house their are many inductive equipments,like fan,mixer,tube choke,air conditioner they also draw PF... by using capacitor can they improve PF. if yes--what are advantage and how to connect a capactor in single ph,and which type of capacitor if no- what are disadvantages.
How can we calculate ac current from the given DC current when AC voltage is given?
How we calculate the Multiplying Factor of Kwh meter for 3 phase alternator.
typically in power distribution substation. 1- Any idea how would be the graph of capacitor bank consumption verses time through the day . 2- How is the switching ( on and off ) of the capacitor bank, per need?
What facility we get after CT secondary earthing and how?
How to reduce -234126219.6403 MVAr generation and by what?
Describe the control mechanism of missile launcher???
Difference between drift current and diffusion current?
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
Define the term factor of inertia.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
