Answer Posted / neeraj chauhan
lap length also depands upon grade of concrete and its genraly use 50 d
| Is This Answer Correct ? | 9 Yes | 5 No |
Post New Answer View All Answers
How can we make a hole in a solid rectangle using solidsworks?
how to calculate load bearing column
What is Refuse Area In High Rise Building ?
What is the diff between cad & cadd?
How many times we can use Fresh bentonite ford wall execution? Would like to know the clear concept of recycling. After flushing can we use it for another time time for flushing? Or we have to use it for for excavation only?
Reinforcement details at hinged joint
What is Rankine Cycle?
3. A vane 12.5 cm long, 8.8 cm dia was pressed into a soft clay at the bottom of borehole. Torque was applied and the value at failure was 55 N-m. find the shear strength of the clay on a horizontal plane.
5. Do you feel that your present employer estimates your full work potential? Are they pleased with your work performance?
while doing the structural works of a simple ground+1 villa, can the columns be continued immediately after neck columns without tie beam, while the tie beam to be done after columns concreting.
How to calculate(Thumb rule) the consumption of steel per cubic meter for different concrete members.
1)What is the total volume of aggregates required for 1cu.mtr.solid hard concrete? 2)What is total mass of wet concrte and dry concrete after 28 days of M25? 3) Is 28 days strength is the final strength of concrete or it gets increasing as the time period increses.? 4)What is the volumetric proportion of concrete grade of M25.M30,M35,M40
in one SQM plaster how much Cement and sand consumed in ratio 1:4
What is the yield of 100 litres of water and 10 kg of cement in grout mix?
can you give me the details of rate analysis of steel and concrete?
