Interested to Buy Any Domain ? << Click Here >> for more details...
short circuit test of transformer gives what?
- 9 Answers
- 15222 Views
- NTPC, I also Faced
- E-Mail Answers
Answer Posted / remya p r
To determine copper loss.
| Is This Answer Correct ? | 6 Yes | 0 No |
Post New Answer View All Answers
What is difference between Over Current & Earth Fault protection?
can the measured percentage error during calibration of single phase energy meter be negative?
In Generator How suction compression power and exhaust works ?
Hi, This is Laila. I am selected for syndicate bank interview. Could you please share your views and the questions asked if you have faced the interview My email id is laila_honey09@yahoo.com Please send as fast as u can.Thank You Thanks... Laila.
how to determine motor size for a fan application?
Why does the rotor rotate?
How a band pass filter is constructed?
What is a DC series motor?
regarding safety what would u consider the most important rules to observe when inspecting electrical equipment?
i am going to correct power factor of 1600kw induction motor,when i calculate capacitance of capacitor it is three time more in star connection than delta. if motor is star connected which connection i shall adopt for capacitors and reason for adopt this connection
with 3 phase board on a 63 amp rcd is it ok to have 6 electrical showers 2 on each phase and what problems could happen
i have to install a HT panel, what components, I have to use in this and what will the diagram of that diagram,please tell me each and everything.
In our plant we have installed new MCC with ELR and CBCT which is detecting some leakage current in the system but it leading to some confusion when to check that in which feeder which is drawing current we put off the whole panel itself but still CBCT detecting some leakage current so can anybody ans me , where i am going wrong or how to detect whether its actual leakage or CBCT malfunctioning.
Which of the following alternatives will be cheaper (1) A 100 h.p AC, 3-phase motor (2) Four motors of 25 h.p each (3) Five motors of 20 h.p each (4) 10 motors of 10 h.p each explain
I am having a 1500 KVA transformer whose secondary current is 2086A and my connected load is 1000 KVA, I am having 400 KVAR APFCR for PF improvement what ratio of CT should i install in LT EB Bus to get optimum PF improvement?
