why overload relay is not tripped at time of starting of
motor allthough staring current is too high?
- 5 Answers
- 9789 Views
- TATA, I also Faced
- E-Mail Answers
Answer Posted / shalini
In a star delta connection, OLR will be placed in the
dealta side.
Starting current would be high during the star connection &
timer will be set to switch over from star to delta.
Once the delta connection is activated, the current would
be naturally less & therby OLR doesnot trip.
| Is This Answer Correct ? | 0 Yes | 3 No |
Post New Answer View All Answers
What is main cause of cable's terminal point burned in Lug on high temperature although lug and cable selection is ok as per stantard and also tightness is ok as per situation. so please take in deep and tell correct answer thanku.
sir, Is their any measuring unit of knoking? please explian?
placement paper samples of mspl company
What is meant by Low Resistance Cable and High Resistance Cable.
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
Define pole pitch?
What is the angle of inclination for the oil connection from transformer conservator to Bucholz relay and why?
What are the insulation standerds for eg H clase and how many insulation standerds are there and its standerds??????
Why the unit sizes of hydro generating machines are not standardized as in case of thermal powerplants?
I have a drawing of a wound rotor induction motor for a crane. This crane motor has 5 forward speeds & 5 reverse speed implemented of course with different amount of resistance for each speed setting selected. What has got me scratching around is the fact that 8 of the 10 speed selections switch in uneven (unbalanced) amounts of resistances on each of the 3 connections to the motor's rotor.Can this be possible? I would have assumed this would produce unbalanced rotor currents and therefore vibration in the motor. I would greatly appreciate anyone's comments on this. Many thanks, Confused.
Generation of voltage for each phase are same of a turbogenerator.Although the short circuit current flow when two phase of turbogenerator are shorted(where current can't flow without potential difference),why?
any body,pls tell me how to done relay coordination ? how to coordinate by TCC curve?how to read the tcc curve?
after how many spot we must chang secondry cable in portable spot welding gun?
I FINISHED MY B.TECH IN EEE . I AM IN NEED OF A GOOD TRAINING INSTITUTE TO DO COURSES .. CAN ANYONE SUGGEST GOOD CENTRES IN TAMILNADU ,BANGALORE ,OTHER AREAS???????
what is mppt (maximum power point tracking ) and how they used in solar power generation ??? what are the main components used in mppt?????
