Interested to Buy Any Domain ? << Click Here >> for more details...
what are the difference between protection class CT and
Class PS CT
- 13 Answers
- 34237 Views
- I also Faced
- E-Mail Answers
Answer Posted / selvam.s
Protection CT:
this type of CT can be used for protect the breakers.
5P10,5P15 & 5P20 are called protection current transformer
1) 5 means accuracy of sensing fault current
2) 'P ' means "protection"
3) 10,15 & 20 means ( no.of times ( 10,15 &20 ) X actual
current rating of breakers .
PS CT:
PS means protection special current transformer.
this type CT can be used for differential protection in
transformer & in alternator.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What is transient response?
how the synchronizing is obtained at bus couplers in grid substation? (because there we cannot change the frequency in one of transmission lines like in generator synchronization)
What is the ratio of true power to apparent power in an ac circuit?
Why let through energy not considered for ACB breaker while cable sizing?
what will happen if multimeter(selector switch at DC voltage) and terminal at current is connected to DC supply?
Why do we perform an open-circuit test and short-circuit test on the transformer?
howmany electrician should maintain for a 1000 kva used plant... in kerala..
Where I can get the sample question for post of Junior engineer electrical-II For RRB Bhubaneswar.
If a surge divertor is required to be protected by 32 amp C Curve Circuit breaker does this limit the amount of protection from surges that you will acheive
What is step signal?
we all know voltage is a force(emf), and the force always devides if 2 or more than2 loads are there but why does the voltage remains same is parallel, it must devide na ???
As we use capacitior bank in 3ph ckt for improvement of PF, why not we use capacitor in single phase domestric use, at our house their are many inductive equipments,like fan,mixer,tube choke,air conditioner they also draw PF... by using capacitor can they improve PF. if yes--what are advantage and how to connect a capactor in single ph,and which type of capacitor if no- what are disadvantages.
how to calculate the earth mat design in 132 kv substation yard ????
WHAT WOULD BE THE FORMULA OF WIRE GAUGE FOR A FULL LOAD CURRENT
how can we save enegry by using VFD for Resiprocating Air compressor which is having more unloading running hours
