Follow Our FB Page << CircleMedia.in >> for Daily Laughter. We Post Funny, Viral, Comedy Videos, Memes, Vines...

• Have you previously successful in this position
progressed to within the company you have worked with?

Answer Posted / rakesh.r

Yes

Is This Answer Correct ?    0 Yes 0 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

How will you size a pipe?. What is Darcy's formula?. From where you will get friction factor "f" ?. In darcy formula substitute f = 16/Re and now you see hf proportional to V instead of V square. How do you explain?.

1361


What is the purpose of scrapper ring

1443


I WORKED AS A Q.C INSPECTOR IN STATIC EQUIPMENT.WHAT ARE THE QUESTIONS ARE LIKELY TO BE ASKED IN AN INTERVIEW.

7772


How can you convert air mass to air volume?

252


A fan is handling hot air at 285 degC with flow of 411635 m3/hr, power consumed is 1165kW and efficiency is 66%. what will happen to flow, power and efficiency of the fan if a water spray system is introduced to reduce the air temperature up to 200 degC? (also please refer any document regarding this)

1138






What does a pump develop? Give reason to support your answer.

250


What is pneumatic system?

220


Purpose of stern tube sealing

1085


What is difference between Higher calorific value and lower calorific value?

2209


sir,iam member to your gk books for one year plan,i have recived every months.i request you i want techical questions pls send as soon as possible

1265


What is the difference between air conditioning and refrigeration?

252


what are the different theories of failure under static load, explain briefly?

270


2. Dry saturated steam at 3.5 bar is expanded through a convergent nozzle to 2.2 bar. The exit area is 5 sq. cm. Calculate the exit velocity and mass flow rate, assuming isentropic expansion and super saturated flow. b) A cast iron cylinder head is fastened to a cylinder of 750mm bore with 12 stud bolts. The maximum pressure inside the cylinder is 3 Mpa. The stiffness of part is thrice the stiffness of the bolt. What should be the initial tightening load so that the point is leak proof at maximum pressure? Also choose a suitable bolt for the above application 2 The propeller shaft of a marine engine is to transmit 600 kW at 1200 rpm, without a significant bending. The efficiency of the propeller is 88% at 32 knots ( 1 knot = 1085 km/hr). If the slenderness ratio is less than 50 and the permissible shear stress should not exceed 65 Mpa. Determine the diameter of shaft. 3 A semi-elliptic leaf spring consists of two extra full-length leaves and six graduated length leaves, including the master leaf. Each leaf is 7.2 mm thick and 65 mm wide. The centre-to-centre distance between the two eyes is 1.3m. The leaves are pre-stressed in such a way that when the load is maximum, stress induced in all leaves are equal to 380 N/mm sq. Determine the maximum force that the spring can withstand

1403


What are the typical indicator diagrams?

1020


What are the types of sensors?

222