1.Why use in ups in software's,reason,and pls explain.
2.what is the isolation transformer and main use it's
functioning and partes.
- 5 Answers
- 6108 Views
- TATA, Wipro, I also Faced
- E-Mail Answers
Answer Posted / anoop
isolation transformer is having same no. of turns in
primary and secondary side as rightly said by one of our
friends. its main purpose is used to isolate/remove the dc
components from ac, as transformer cannot transform dc from
one circuit to another because there will not be any rate
of change of flux associated with dc. so sewcondary side
Kva will be dc component free.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
3 phase induction motor connection star or delta while using ac drive motor is .75 to 5.5 kw
how to calculate current carring capacity of cable and cable selection? 1) copper flexible cable 2) copper armoured cable 3) Aluminium cable
we have 3.5MVA-11/6KV transformer. how can we calculate earth fault current and NGR calculation?
What is the current carrying capacity of 0SWG,3SWG,10 & 12 SWG solid bare overhead copper conductors?
In siemens S7-300 PLC, what is function and function block ? What is the difference between them ? When to use function and when to use function block ?
Earth has zero potential then what would be the neutral potential ?
What is mean by hot and cold loop testing? What is the difference between them?
Why the power factor improvement is so important in industrial loads
How out of step protection relay works?
What is the theoretical reason for the size of a zig zag grounding transformer to be 1.732 times less than that of a wye-delta grounding transformer used for the same application?
Explain the method to keep noises low in a control system?
why should small green grass ans small plant should not be there inside the transformer Yard in the factories
I have a current transformer with 1 main reading meter with transformer outside the building and a control panel having 5 CT reading meters with black round coils inside the building. I want to know, A) when current pass through the Transformers, will the current be reduced or be the same and after that B) when current pass through the CT meters with black round coils, will the current be reduced or be the same. C) in the above process will the reading of the main meter be same or different, from the total reading of all the 5 CT meters.
what is the minimum (Common factor) insulatin resistance of the following a, 4mm sq wire b, cable from 50 mm sq to 800mm sq
