Answer Posted / engineering.force
u can check if a battery is fully charged or not by
measuring its specific gravity and comparing it with the
manufacturer's data sheet mentioned specific gravity when
fully charged. if they are equal means that the battery is
fully charged. if not, the battery is not fully charged. the
above answer is battery specific, i.e. depends on what kind
of battery is used in what kind of application. the above
mentioned batteries are generally used in the sub-stations
or LDC's for the the power supply back-up or to operate the
CB's in case of ac power failure, or to act as back-up power
supply for the SCADA/PLC etc.
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is the difference between solid grounding and impedance grounding?
How to calculate the fuse rating depend upon the DC circuit?
What is the difference b/w fanuc alpha series 16i and 18i controller. what is stand for i
what is induction furnance? how many phase supply given io its coil for 15 or 20 ton furnance?
can u please mail me the syllabus for GET exam for damodar valley corporation?
How much ph is maintained of water resistance starter for slipring induction motor ?
2. Modify your design in question 1.a so that the circuit works according to the following function table X Y F 0 0 Clear 0 1 No Change 1 0 Parallel Loading 1 1 Count 3. Design a circuit that detects the pattern 010 in a serial input X considering: 3.a Overlapping 3.b No overlapping
What do you mean by Stimulastion Test in Diesel Genarator / Why & when it's conducted ?
hwat type of motor is used in thermal gas turbine hydro nuclear power plants and why
Why CBCT rating is 50/1A
Explain the different regions in frequency response?
any one guide me to reduce the power factor of diesel Generator from 0.97 Leg to 0.8 Leg.with out any change in my load.
how to calculate singlephase motor efficiency?
What is cross over distortion? How it can be eliminated?
What is the different types of cable & current capacity of cable