Interested to Buy Any Domain ? << Click Here >> for more details...
what is dead weight tester and where it is used?.
- 11 Answers
- 21447 Views
- DuPont, Jain steels, I also Faced
- E-Mail Answers
Answer Posted / prasad
dead weight tester is preasure calibration equipment used
ininstrumentation calibration labs basically meant for
calibrating preasure gauges,transmitters, preasure switches
etc.it is a primary standard for preasure calibrations
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
How to Calibrate Ultrasonic flow Transmitter in Field
What is the GK Value in Flowmeter?
What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
Where is wet leg is used?
how will you check torque value during Factory acceptance Test for control valve/ESD ON/OFF VALE how will you confirm this torque value is being correct, Which document will you be refer.
how many types of spped sensors n vibration sensors?their basic principle n connection?
A PLC is programmed to drive three motors A, B and C as follows : After running motor A for an hour, motor B should get ON and motor A should get OFF. And after running motor B for an hour, motor C should get ON and motor B should get OFF. And after running motor C for an hour, motor A should get ON and motor C should get OFF. (That is, a cyclic repetition with time period one hour) Now, the second condition is: If any motor gone faulty and is tripped, the consecutive motor should get ON and the faulty (tripped) motor should be eliminated from cyclic repetition. The remaining two motors should bear the cyclic repetition of one hour each. (For healthy motor take logic as high and for tripped motor take logic as low) Now, the third condition is: When motor A load(Amps) exceeds 60% of its rated load, motor B should get ON in parallel to motor A. And when both motors A & B are running in parallel, and if their load exceeds 60% of their rated load, motor C should also start in parallel to A & B. [Here the cyclic repetition is eliminated, until their loads become normal(40%)] [Take logic high(1) for load at 60% and logic low(0) for load at 40%] Now draw a flow chart or a ladder diagram to fulfill the above condition.
what is interface level and how it is calibrate?
Difference between ultra sonic flow meter
What is the use of temprature compensation?
I am teja. I am studying Msc(tech) Electronics and Instrumentation (3years course) in Andhra university. But my course is not recognised by UGC and AICTE. Please tell me the job opportunities after this course. And i fineshed PLC course in IGIAT ,Vizag.Also complted my short term coure in SCADA, Seimans WinCC in ATI,Hyd.After Msc can i join Mtech for good job? or phd. How i can get good job in INdustrial Automation Side. Please give replay.Because this is my life matter.
hi sir yhis is zahid ali i am preparing for the jspl at oct.4.please send me the recently updated sample paper.
Why do we have earthing cable in branch cable and shield in the same cable?
how to convert MA in to measuring values..and how mwasuring values into MA ?..plz ansr.i have intervw
please any body have most important data for study for saudi aramco test of instrument QC thanks email shahnaveedullah@gmail.com
