Interested to Buy Any Domain ? << Click Here >> for more details...
why microprocessors are named as 8085 ,8086 etc?
what's the reason for this???
- 15 Answers
- 44060 Views
- Bhel, HCL, I also Faced
- E-Mail Answers
Answer Posted / avanthika
for 8085 as we are using only 5v power supply the last
digit of processor is 5
for 8086 as the width of ALU is 16 the last digit of 16 is
the last digit of microprocessor 8086 ie; 6
for 8088 as it has 8bit bus the last digit of processor is 8
| Is This Answer Correct ? | 3 Yes | 11 No |
Post New Answer View All Answers
Grid fault level [KA]?
Assuming that a dedicated neutral earthing transformer is provided for each GT generator, when the two generators are running in parallel, has consideration been given that the earth fault current from one generator stator winding be split between the two neutral earthing transformers? If so, what adverse impact will this have on the operation of the 59N and 27TN devices?
What is cut-off rate?
1. Design a counter which counts 0, 4, 8, 2, 6, and repeats using: 1.a using JK flip flops 1.b using T flip flops 1.c using D flip flops
Can anyone explain me about the capacitor calculation
what is the use of Auto re-closer?
Draw a block diagramof Three UPS systems connected in Parallel mode?
Purpose of providing neutral isolation panel for parallel operation of diesel generator
I am experienced with house and industrial wiring but I don't have any licence how can I apply an licence and which type of licence i can get i didn't complete deee just only experience
wat is the first thing dat is needed, 2 lay a cable in some area??
How to decide the size of the capacitor for a single phase induction motor say 2 HP ??
What is step signal?
I have a relay contact rated at 220v dc which is supplied with a 24vdc from the panel,for it to trip the dampers(24vdc).What if the application of the relay changes so that it should work at its rated 220vdc then will it work at 24vdc supply given or any other consideration needs to be taken .....
What is meant by Low Resistance Cable and High Resistance Cable.
how to calculate slip ring induction motor stator and rotor currents??
