In thermocouple could we use the lug for termination or
not,Thermocouple is any time,I am currently concerned with
K type.please let me know if anybody know
Answer Posted / bm
Dont see any harm in connecting lug for termination
provided the continuity remains the same i.e there will be
very very less resistance drop if proper connection is not
there with thermocouple wire, lug and the terminals.
Is This Answer Correct ? | 6 Yes | 5 No |
Post New Answer View All Answers
I was working on calibrating turbidity transmitters endress+hauser at effluent polishing plant.We calibrated using NTU buffers.What happened is that when we immersed the sensor, everytime we raise and lower the sensor gradually, the reading will vary.my question is that is there any specifications on what is the required distance from the bottom of the container with buffer to the face of the sensor?Is it ok to install the sensor in a medium which has turbulence specially if bubbles are present?
What is critcal speed. what is resonant frequency. why we want to cross crtcal speed on higher RPM (early).
what is cems analyzer explain with principle and drawing ?
How can we use feedback signal frm rtd for monitoring and in dcs for controlling ,then which type of rtd is sutaible 2 , 3,4wire and why ?
What is the constant voltage unit?
what is insdustrial vibration.who it works. give atleast 2 types of insdustrial vibration
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
CONTROL VALVE OPERATING IN MANUAL BUT NOT IN MANUAL. WHAT SHOULD BE THE PROBLEM ?
How many interlocks at turbine side?
How to calibrate displacer type level transmitter (chemtrol make )for level measurement in hotwell , LP & HP heater ?
What are the different types of thermistors used in industries? How to the operation of typical thermistor?
sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com
How to calibrate H2s Dectector
How can test or measure the probe and extension cable to identify if the problem at the probe or cable or at the driver it self? (pleast notify the measuring method)
Explain the working of an electronic level troll.