Interested to Buy Any Domain ? << Click Here >> for more details...
why dc supply is not applied for step up or down in
transformer
- 3 Answers
- 6193 Views
- I also Faced
- E-Mail Answers
Answer Posted / janarthanan.v
If we give dc supply to the transformer there won't be any
frequency or flux in DC supply .So there won't be any output
in secondary side and on primary side there will be no self
induced emf to limit the primary current.This makes the
primary current to burn.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What is super thermal power plant? and how it will differ from normal thermal power plant
what is the formula to calculate voltage drop/loss on 66KV Transmission Line?
1.how many earth pits are required for 1000 k.w plant include substion , transformer ? 2. how many earth pits are required for 500kva generator.what is formula to calcute?
What are the disadvantages of thermal power plant?
How to find out damper winding failure for synchronous machine?
Why does the adjacent zone of protection overlap?
what parameters are should nessary for control technic dc drive(in rolling mills)?
how to CHECK CT AND PT AT THE FAULT OCCUR IN GENERATOR RELAY PANEL .
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
In Electrical 'Single Line Diagram' cable nomenclature shows "2 X 1C X 630sq.mm to be provided for one incomer. The question is how many cable to be proved for one Incomer.
i am completed in B.E(Electrical and Electronics Engineering) with 8 months experience in Quality Control Engineer at Bharathi Industries,Coimbatore.
When we have earthing mesh or underground earthing network in industrial plants, weather we have NT-S or NT-C-S kind of earthing system, so eventually weather we must use 4 or 5 wire in 400 volt level (For example 3×150+70 mm2 or 5×150 mm2) in this connection I would like to know exactly the paragraph of IEC or IEEE number
An impedance of 100 ohms resistance and an unknown inductance is connected across the capacitor. The resulting impedance is a pure resistance of 500 ohms ifω = 10^5 rad/sec. calculate the values of inductor and capacitor.
I need HT sphere gap calibration table. Can any body help me.
why the rotor current becomes in steady state during high slip region? please verify with equations.
