Interested to Buy Any Domain ? << Click Here >> for more details...
How data flow from source to destination please Explain each
step from layer to layer?
- 3 Answers
- 9247 Views
- Cisco, HCL, I also Faced
- E-Mail Answers
Answer Posted / sandeep kumar
1-data send in raw bit form to physical layer.
2-now it comes into frames including,senders mac address at
the data link layer.
3-then it comes into a packet send through the network
layer device through network layer.
4-at this layer the transaction is imposed on the packet at
transport layer.
5-there is a session attached to the packet during the
transmission at the session layer with security and
handshaking.
6-at the presentation layer the packet reached at the
reciever end.
7-the data will be show on in the form of, including
text,images,and some graphics through the http, at
application layer.
| Is This Answer Correct ? | 2 Yes | 0 No |
Post New Answer View All Answers
What are the two reasons for using layered protocols?
What is virtual channel
If the transmitted code word is 10011000 and the received code word is 11001001. What is the error word ? Write transmitted code word , received code word and error word as polynomials.
Describe and distinguish between FDMA, TDMA, and CDMA.
what is basic of networkin ?2.what is main topik of networkin ? 3.how installed the software and drivers ? 4. how to connect the pc and net?5.what uses of protocol in networking,and tell main proto of netwo
what are the two sub layers of data link layer called ?
how many types of backups are there & explain them in theory mode & practical mode?
I have 2 networks. One is LAN & other is Tata Indicom Modem which is connected to USB. The problem is that When USB Modem is using, i am unable to use LAN. And when we use LAN, we cannot use USB Modem. kindly help me.
Question What is datagram, datagram packets and datagram sockets?
Is the nyquist theorem true for optical fibre or only for copper wire ? Explain.
Give two examples of a ‘collision-free’ protocol ?
Differentiate between IEEE 802.3, IEEE 802.4 and IEEE 802.5 standards.
Why do data link layer protocols position the checksum in the trailer and not in the header ?
What do you understand by the term ‘structured cabling’. State the main rules that should be used when installing a cable. 31. Show that maximum cabling area for LAN for horizontal cabling runs is approximately 200m.
Enumerate the main responsibilities of data link layer ?
