Structural steel: For a thumb rule check in field, the
allowable weight which can be hung down for 10mm dia mild
steel rod, of yield value of 0, 25 KN/mm2 and applying a
factor of safety 2.00, will be how many kg?
Answer Posted / somnath dutta
total load can carry= .25*area of the bar(78.53)=19.63KN
if the F.O.S.=2, then the ultimate load on
it=19.63/2=9.81KN=9.81 x 100 = 981 kg ( 1 KN = 100 Kg)
therefore, the maximum load is 981kg.
| Is This Answer Correct ? | 7 Yes | 0 No |
Post New Answer View All Answers
What are the RISKS during the project construction?
why demand factor less then 1 ?
Explain the difference between shear and tensile strength.
What is quantity of cement and sand required for 2000sqft of tiling?
how to calculate detail quantity of bricks and mortar for 500 cu.ft masonry work. consider wall thickness 9 inches
what is the specific gravity of rubble in plum concert
the magnitude of the buoyant force can be determine by newtons law of viscosity archimidies principal principles of momemnt none
why the openings of sieves are square io size?
What are the uses of groynes?
Stringer How many cm goes to landind
how to find out hard strata in bored pile when the DMC method adopted.
how to convert cement, sand aggregate quantity from M3 to kg with full description?
i) Distinguish between Theodolite and dumpy Level? (Marks-8) ii)Distinguish between Viscous and Turbulent flow? (Marks-8) iii) Distinguish between nominal and design mix? iv) What is standard sand? v) Explain the term plane stress? Vi) Differentiate between principal plane and principal axis? Vii) write short notes on Elastic limit of structural steel? viii) Write short notes on stress concentration? ix) write short notes on "Grading of Sand" ? x) How many grades of concrete are there under standard concrete?
What is thumb rule in quantity and cost estimation of a residential building?
How do you determine specific gravity of cement?