what is 1st angle & 2nd angle drawing difference?
- 2 Answers
- 7302 Views
- ITC Infotech, L&T, Mercedes Benz, I also Faced
- E-Mail Answers
Answer Posted / b.veeranna
In 1st angle drawing front and both side views are above the
reference line and top view below the reference line
In 2nd angle drawing front,both side views and top views are
above the reference line
| Is This Answer Correct ? | 14 Yes | 5 No |
Post New Answer View All Answers
can any body sand me previous exampapers of jr. engineer (mechanical)
I WORKED AS A Q.C INSPECTOR IN STATIC EQUIPMENT.WHAT ARE THE QUESTIONS ARE LIKELY TO BE ASKED IN AN INTERVIEW.
in tpp how steam pr. decreases from steam drum to main steam line
Enumerate the cause of pumps low delivery of water
Why pistons are usually dished at top ?
we use parallel flow heat exchanger to coo oil of 1000 EP viscosity,oftenly tubes may damage during cleaning etc what is proper way to clean cooler? How impurities decreased or vanished during working or in less teme job performed?
What was the hardest part of obtaining your engineering degree?
Why an increase in area is required to produce an increase of velocity in case of supersonic flow ?
how can you describe yourself
How should I begin a conversation that I need a change in the job to a known person in his organisation?
which technology use in bikes
Dear Friends I want to previous 5-10 years technical and non tech. question paper of section engineer (mechanical)of RRB and also tell me how should I prepare for S.E. and which books will help me for technical,aptitude,resoning.plz send me at bkcs.bkcs@rediffmail.com
What type of pump use in boiler F.O. system?
Identify or enumerate the parts of stern tube
Which element causes difference in higher and lower heating values of fuel ?
