Interested to Buy Any Domain ? << Click Here >> for more details...
suppose in dcs range of a flow transmitter is 10t/hr what
is dp for 50% in 2500mmwc
- 6 Answers
- 13091 Views
- Chevron, I also Faced
- E-Mail Answers
Answer Posted / mithilesh kumar
tx range in dcs is 0-10 t/h.ok.
if ur TX showing 50% and 1250 mmwc then after square root
it is near 70% then in dcs ie that flow is 7 T/H.
if tx is showing 25% then this time mmwc will be 625.
after square root it is 50% and in dcs shows 5 T/H.
any comment u welcome
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
What is surge and how is it prevented, what is the purpose of bypass valve across AS valve.
field bus transmitter calibration procedure tell me
What are different types of orifice plates? State their uses.
what are the definitions of input, output, command & signal according to instruments controlled by PLC using DCS System?
what is output of FOUNDATION FIELD BUS transmitter
what is sil (safety integrity level
Isometric drawings are generated during _________________ phase of a project
what is the minimum power (P=VI)to produce a spark?
How we can check the 2 wire proxy switch? & how it is connected to DI MODULE OF PLC?
centrifugal compressor interlock? Tell me the parameter at which compressor will trip
how to design orifice plate?what is the equation?
can anyone tell me about the basic concepts to consider before to start a PLC panel wiring
What is the purpose of LO Overhead tank in turbines.
how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i
Why 4-20 amps is being used in instruments? Why cant we use any other range instead of 4-20 amps? Why only 4 amps is taken as lower limit and why 20 amps is taken as the higher limit?
