hi this toufik here. i am doing my b.e.degree.now i am in
final year and supposed to do a project in this year so i
thinking to control the buchholz relay using software base
means checking the status of transformer oil using
microcontroler, plc or scada. so can i do so...??? alz
suggest me...
Answer Posted / vicky
ya toufiq.. i think u can do it.. but it seems in terms of relay, u r required to use more voltage n current.. in this interrupting with micro-processor r controller.. i think it may b difficult..anyway it s a good idea.. analyse ur doubts wit ur staff who know abt mp clearly.. all d best man..
Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
what are the differences between 'exhaust fan', 'heavy-duty exhaust fan' & 'super heavy duty exhaust fan'. what are their power ratings ?
In Air circuit breaker LSIG protection unit is used. Without fault in cables (2 runs 3Cx150Sq.mm Copper, 1Kv grade, XPLE armored cable IR value is more than 550Mohm @ 500V Megger) and load section Long time Overcurrent protection is triggers and trips the unit. We changed LSIG protection with new factory tested unit. Even then fault is persisting. Please suggest the possible causes
how to test reverse power trip?
How we calculate DC inducation moter Amp? Sir pls give me formula......
what should be correct gas pressures to be a 1.5 ac unite
how give earthing conection to household equipment?
what is effect of length of air gap on performance of dc motor and generator?
what are inherent currents?
Explain Circuit Breaker Trip Characteristics in detail.
I meggared my 2c*70 sq mm AL AR XLPE cable. its one end show 50 M ohm . is my cable is safe for laying. I have only one phase and neutral.
Comment on the working principle of operation of a single-phase transformer.
Can any body tell me the different types of LT cables & their application.
sir,in our plant we r using SATEC PM172E power reading meeters in HT panel side it is monitoring the MB data smart viewer(sever).but last one week we did not get readings inthe server only available in meeter.tell me how communicate meter and server. and also what steps we take for checking.
I have iti elec, 1st aid, and 5 yrs experience in 7.5 mw power plant. Am i eligeble for 11kv license in telangana state..when, how to apply for that.?
What is stacking factor? What is its approximate value?