Answer Posted / anil yadav
Earthing is the part of process to transfer the charge in
the groung.and it is part of neutral.Neutral means nothing
it is just like a passing your body to charge and through
the groung.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
What do you mean by ratio correction factor of instrument transformer?
how to calculate fault level?
A 100W electric lamp is supplied from a 115V, 60HZ source. The peak instantaneous power dissipated in the lamp filament is
Lt motor sfu flashing reasons?
How to synchoronize the generator (with gcb,GT) to grid????? ????? from Grid iam getting power (rated 400kv/20kv) through GT and its goes to UAT.,,ST.,, now my generator(rated 20kv ) ready.,, now iam closing my GCB.,, in GT iam suddenly giving 20kv on that Gt.,, what will happend
Which power will flow first if we switch on a motor Active or Reactive? How?
if there are six generators (3 gas CATT, one Jenbacher o1 MW each, and two nos Diesel 01 no 01 mw other 0.65mw EDGs ( say), 3 CAtt gas set have identical pole pitch,01mw EDG and Jenbacher gas Set have different pole pitch, how their power connection can be done to connect a common bus bar during installation. in short, how different pole pitched generators power connection can be done to connect a common busbar system through generators incomer ACBs.
How the annunciator works ? How to do its wiring
What are the different types of hydro schemes?
What is the RMS and DFT principle of analogue maesurments. Which way they are advangages. where which princples give optimum results.
We have a couple of oil tanks at our plant. One of them does not have a lightning arrester installed. My question is it necessary to install an arrestor on every tank or will this particular one be covered by the arrestor installed on the ajdacent tank, Since all the tanks are close to each other. Basically, I want to know that if these arrestors or protection works in a parituclar area of effect or influence. Thanks
which is better to use svc or synchronous condenser why ?
Why do we use center tap transformer that used with portable tools
State ohm’s law?
Ratings of power transformer,Distribution transformer.