what are the advantages and disadvantages of oil filled cables
over XLPE cables
Answer Posted / anil
now most of the HT and EHV cables are with XLPE insulation.
earlier, in mid 70's HT cable are insulated with PILC(paper
insulated and lead covered. OIL is filled to reduce moisture
in paper. disd of PILC cables is very heavy almost double
the weight of XLPE cable but adv is the chance of voids are
very less in PILC cable. Lead is not ECO-friendly,it is
almost banned in europe, US and few countries in ASIA. Cost
is very High as compare to XLPE cable. whereas XLPE cable
are lighter in weight.Long life,easy to handle. jointing is
less costly.
Is This Answer Correct ? | 5 Yes | 1 No |
Post New Answer View All Answers
How earthing of switchgear system to be done.
what is the difference between switch yard to residential area.and how much required it.
i am an maintenance engineer. one distribution board have 5 feeder. recently its ELR trips frequently, but it take some times after trip( 10min,20min..)but 3 feeder no load. two feeder only loaded. i checked one feeder IR value all values are above 50Mohm.but B phase to Earth is only 9Mohm.any problem about low value
DIFFERENCE BETWEEN NORMAL TRAFO AND THRISTER TRAFO?
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
What should be the Sandwitch type Al. bus bar capacity for 2 M.W.Gen. set, having continuous full load current- 3463 Amps,ambient temp.- 50 Deg. C., Required temp. raise-20 deg.C., it will run 24 hrs, 365 days on full load, required highly reliable.
How do i perform grounding of star point of Genset (400V) for making connection with step up transformer of DELTA-DELTA (400V to 20KV) ? while Genset itself has its own neutral and grounding bus bar inside genset breaker box whereas we have another neutral and grounding busbar in synchronizing panel next to genset at maximum distance of 6meter, would someone pls advice if we can only perform neutral grounding in synchronizing panel or should we ground neutral on both places inside genset breaker box and synchronizing panel.
Why we cant store an ac power. If we coo store in which device we can?
please send me previous year questions of jspl through which i could prepare myself for the test.
IF ANYONE HAVE ANY QUESTION ASK ME AT MY MAIL anmol.bhardwaj5@gmail.com
what are the differant std sizes of cable trenches?
11000volt DG set carnt kaise banvay
what is an unbalance in acircuit? in a three phase 3wire circuit how an unbalance will come? in a three phase four wire system how an un balance is coming?
In a tap changing transformer where is the tap connected, is it connected in the primary side or secondary side?
List examples of voltage source?