why using 4-20ma not using 0-20or why not using 1-
20ma???????
- 7 Answers
- 7308 Views
- I also Faced
- E-Mail Answers
Answer Posted / nilesh
This is a universal standard adopted.4 mA at 0% ensure live
zero.
| Is This Answer Correct ? | 5 Yes | 7 No |
Post New Answer View All Answers
Whether the DI, DOs shields can be connected with Analog Input Shield Earthpit?
What is the difference between conductive lined pipe and conductive unlined pipe? Why do we see that?
What are the error values can accepted in flow transmitter calibration?could u give any formula for this?
What is Span Error
any body please send me the old question papers of ongc test.
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
what is compensation? temprature & pressure
Specify for Cables - Flame Retardant and Fire Resistant?
What is the use of single seated valve?
the pump holds on run indication into the dcs and filed local control panel remote push button condition operaton wrong like when the push button pushing conditions the pump is off and the push button release condition the pump is on totally opposite condition . And control room inside give the stop command into dcs just 1secon relay engage and again normal condition. How can I slove
How is PH sensor works ?
How many interlocks at turbine? Plz explain briefly
what are procedure of sox-nox calibration
how do calibrate the valves.. with clear manual
A length of steel pipe is used to carry sea water to a desalination plant. An adequate corrosion allowance must be specified and indicated in the piping specification, which affects the _________________________ of the pipe
