Answer Posted / ajay

init 0 -ok prompt(open boot prompt)
init 1- single user with system administrator mode.
init 2 -multi-user mode.
init 3 - Extend multi-user mode
init 4 -Is available to be defined as an alternative
multi user environment configuration. It is not necessary
for system operation and is usually not used.
init 5 - Shut the machine down so that it is safe to remove
the power.Have the machine remove power, if possible.

init 6 - Stop the operating system and reboot to the
state defined by the initdefault entry in /etc/inittab.

what is the difference between solaris8 and solaris9 and solaris10

5340

---

What does pkgadd command do?

1085

---

How to make SUN server as router in subnetwork?

2604

---

If the root disk is failed how can change it?

2425

---

After first installation of Solaris 10, what and all the Securities We need to set and how ?

2267

---

There are two nic cards on a sun server. I need to connect one nic to pupic ip and another nic to DMZ. Could you tell me how to configure step by step?

2533

---

Hi We have upgraded our sun machine from solaris 9 to solaris 10. Before upgradation the date command output(Solaris 9) Wed Oct 13 09:45:21 IST 2010 But after upgradation the output for date is as below(solaris 10). Wednesday, October 13, 2010 9:46:14 AM IST Looks like I need to change LC_TIME=C. can you please help me how to change it for permanently

2199

---

Write the steps involved in creating and executing a program to implement the “case” command.

980

---

What are the differences between the command line and graphical user interface?

1116

---

what are the alarms in solaris?

3150

---

Where do you get Alarm prompt?

2739

---

please post step by step installation of packages from the EIS cd..

2245

---

How to add a new LUN in exit disksets (metasets) in solaris please answer me step by step procedure?

3893

---

Which command is used to backup and restore solaris file system?

1077

---

How can u find a file which is logged in last week?

2694

---