Interested to Buy Any Domain ? << Click Here >> for more details...
We have 2 no. 4MW DG set. and GEB supply.
But, we running, only 1 DG set. when we done APFC/Power
factor setting : 0.90, then winding temp. Low. but when
setting done : 0.83, then Winding temp. increase.
WHY Why ? ? ?, plz give me answer.
- 4 Answers
- 7452 Views
- I also Faced
- E-Mail Answers
Answer Posted / rajnikant dodiya
Simple,
power factor increse, current decrese ane hence losses
(I^2R) reduces. But if Power factor reduces, losses
increases with square of current which makes dg to be hot
compared to increase pf.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
SUTIABLE FOR ohm's law super conductor
Where is the best place to mount distribution panel in a house.
HOW TO CALCULATE HV CABLE SIZING?
HOW MUCH CURRENT DOES SYNCHRONOUS MOTOR TAKES AT SYNCHRONOUS SPEED IN NO LOAD CONDITION ?
WHY EARTHING NOT NEEDED IN BATTERY IN SUBSTATION
wht is embedded systems? what is new inthis field?
what is the difference between electrical and electronic choke?
my UPS suddenly goes off and all panel light also blow off.This happens even main electric supply is not interrupted.After some time it automatically starts functioning normally.Batteries are new.
How each of the following losses occur in d.c machines (i) copper (2)core (3) windage (4)friction please help me
Why a tesa lamp is glow between two phase?
What is the principle of HIGH SPEED DIRECT DRIVE MOTOR ?
What is the accepted limit to increase the choosen transformer capacity over the load and why ?
how to erect roof control panel?
How to Preparation of online test
how to find impedance , mutual indatnce in transmission lines
