Interested to Buy Any Domain ? << Click Here >> for more details...
We have two 1 phase heating coils having same resistance
of 25ohm, but during operation one takes 3A and other 6A
Is it posiible Pls. explain
- 5 Answers
- 6864 Views
- Bhel, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
The coil wound over an insulted iron former will draw less
current.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
why we have to particulary use ACB for below ratings,even available of MCB,MCCB with that range ?
What is transmittance?
Why is the starting current high in dc motor?
What is the maximum number of swithes that can be connected in series up to down stream point in an LV Distribution system?
what is mean by restructuring power system?
How to size Air Circuit breaker (ACB)? What is the most important factors?
excitation limit of an excitor
Brushes are placed at magnetically neutral axis,when brushes reach that point,the armature conductor gets shorted,but it can be seen that the dc supply is also shorted,wont that get damage? help me plz
What is the difference between the impedance percent and impedance voltage ?
WHAT ARE THE DATAS REQUIRED FOR PROTECTION AND METERING AND CONTROL AND LOGIC PREPARATION,HOW TO STUDY THE PROTECTION AND METERING?
what is acceptance test in electrical engineering.
Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.
what is KSR type transmission tower? What is LSR type transmission tower?
UG cable sizes were specified in sqmm. But practically its not coming to mesure. What's the reason for that? And how they specify the size of the cable?
why does a dc machine has high efficiency while working as a generator than as a motor ..
