Interested to Buy Any Domain ? << Click Here >> for more details...
Why the tapping connections are taking above for gas
service and below for liquid service?
- 4 Answers
- 8666 Views
- I also Faced
- E-Mail Answers
Answer Posted / msn raju
Because gas want to went to atmosphere upside always and liquid always downside
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
What is the constant voltage unit?
State some of balance principle’ advantages?
Coal mill Instruments Equipments for cement plant And process diagram ?
How INtools is useful for routine Instrument maintenance?
Tr. Wiring for calibration.
Explain why use mmwc unit?
our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS
how to turbine speed measurement?
Please can anybody help for control valve sizing step by step procedure?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
in which principle pressure tx,level tx ,flow tx,temp tx ,control valve works?
give me the formula for analog to digital converter and also d to a converter
How to calibrate radar type level transmitter for interface level? Total liquid(liq.1 and liq.2), level both the liq individually? For. Both the liquid levels how the signal will go from transmitter to dcs? How to calibrate. Single radar 9:26:55 AM for 2 different liquids in a tank?
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel
