Interested to Buy Any Domain ? << Click Here >> for more details...
if suplly 11kva its give 440volts then if suplly is given 10kva whats the volts given
- 3 Answers
- 5665 Views
- I also Faced
- E-Mail Answers
Answer Posted / anil
there will no change in o/p voltage as it is designed for
440 volts.value of current will change.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
main difference between ac and dc?
Can we indroduce the principle of single phase induction mator to Transformer? i.e. by Producing rotating flux in the transformer.
Why hydropower stations are preferred solution for meeting peak loads in grids?
WHAT ARE THE EFFECTS OF SERIES RESONANCE AND PARALLEL RESONANCE ON THE CIRCUITS PARAMETERS?
What are test signals and their significance?
1)How much current can a 3-1/2 core 100 mm wire carry? 2)What are the special cables required for explosion proof wiring? 3)In case you do not have coal and salt for earthing, how can you achieve good temporary earthing? 4)One horse power single phase motor is more likely to get hot than a one horse power 3 phase motor. Is it true or false, if true why? 5)What are the different types of soft starters for large motors?please explain?
why do we use spark detector inside the slip ring brush compartment 0ona slip ring induction motor?
What is NGR . What is the purpose of 10 sec ,60 sec rating of NGR.
in a solar power plant,we are going to step up the voltage 350V to 33kv, and to 132kv GSS. i want to ask that if it is possible that 315v/33kv is not possible because we also use 315v/11kv. or it should be 415v/33kv? is it effects generation or losses? the second question is-generation is depends on LV winding? or LV winding design for generation voltage?
how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?
Explain RLC circuit?
What is inrush current?
how dia of wire and angles are calculated for overhead shielding wire to protect substation equipment from lightening strokes???
ii) A shunt motor supplied at 230V, runs at 900 rpm when the current is 30A. The resistance of the armature is 0.4 ohms. Calculate the resistance required in series with the armature to reduce the speed to 600 rpm, assuming that the armature current is then 20A. [12]
WHAT IS FAULT CAPACITY OF HT MOTOR TERMINAL BLOCK? ANY BODY HAVE ANSWER PLZ....POST IT.
