Interested to Buy Any Domain ? << Click Here >> for more details...
In transformer which temp should be less oil temp are
winding temp?
- 7 Answers
- 16642 Views
- TCS, I also Faced
- E-Mail Answers
Answer Posted / sathiyamurugna
normally oil temperature should be less compared to winding
temperature because transformer oil used for cooling the
winding. if oil temperature should not go high other wise it
will not cool the winding properly
| Is This Answer Correct ? | 39 Yes | 0 No |
Post New Answer View All Answers
why is the conservator tank painted white on the transformer
How servo stabilizer works.
In Power Line Communication (PLC) the wave trap is used to block communication signals from entering neighboring lines. My question is this: Why do they allow for different filtering arrangements on these wave traps? Isn't it always going to be a low pass filter since we want the power frequency to go through, and the comm signal blocked?
How to do cable earhing? whether by grounding Armour to ground or by running extra G.I wire along with cable? which one is preferred mostly amoung them? If the second one is more preferable how many GI wires to be run along with cable (1 or 2)?
What is the Load Capacity of Panther conductor (0.2) and dog conductor (0.2)
Can we transmit digital signal to long distance ?
what are the components in electrical control panel (for example: 415V, 3-ph, panel to operate utility and 3-ph DG set).
how to apply b license to c license in tneb
Write the force balance equation of m ideal mass element.
How to design inductive load for 3 phase 440v and maximum 5 amps for star or delta? Can we use a 15kW, 1450rpm motor for 15kW, 960rpm apllication?If yes.how......n.if thesame motor used what`s it`s sideeefect.
Is there a diode made that works with AC 120 volt 20 amp? If so can it completely stop all current flow in 1 direction at all times?
what is mathed of check the D.C MOTOR 181 KW (ARMATURE AND FIELD) WHAT IS THE MATHED OF CHECK THE THYRISTOR MODULE (HIGH CURRENT)
whether starting current is limited to rated current of motor through soft starting or it exceeds the rated current?
In how we connect watt meter for open & short circuit test of a single phase transformer.
after how many spot we must chang secondry cable in portable spot welding gun?
