Interested to Buy Any Domain ? << Click Here >> for more details...
how to improve IR value in HT motors?
- 3 Answers
- 17558 Views
- ABB, AMW, Macleods, I also Faced
- E-Mail Answers
Answer Posted / k.prakashchandra
With dimmer-stat (auto-transformer),it may not be possible
to get full load current in large motors .Then you have to
use strip heaters for heating the coils or DC supply (no
back emf)
| Is This Answer Correct ? | 4 Yes | 1 No |
Post New Answer View All Answers
if 3400kw slipring motor rotor shorting done and motor started on mv drive ,what will be the rotor shoring current
how to calculate fuse rating for a motor
Why the earth to phase voltage is high 250 compare to other two phases
Haw to check conductivity of budbar
In india, according to trade theory above 5 HP motor reqired star delta starter. But we R connect 11 KV motor with 14MW in Direct to line ( With VCB starter combination) Can U Guess, How it is possible ?????
if sf6 gas low in gis what will happen
How can calculate the earthing strip of Copper/GI for rating of 30kV,discharge current 10KA Lightning arrester.
WHAT IS THE FAULT WHEN 100HP TURBINE MOTOR TRIPS, LIST THE FAULTS AND ITS TRABULESHOOTING TIPS.. MY AUTO TARNSFORMER STARTER TRIPS
how to ctrl motor by use of ac or dc drive.plz explain evdintly
Instrument connected to a single phase supply
Why is it prefer to initiate circuit breaker failure by "86" lockout relay not by "94" tripping relay ?!
On Which Pressure PRV is operated.
In an ACB shunt trip coil and undervoltage coil operated normally( breaker open and charged). But closing coil not operating untill manually discharge and recharging. Any help.
In case of HV test on medium voltage cables, BS is asking for 4 U0 where as IEC is asking for 3.5 U0. Can any one advise me how this 3.5 times or 4 times U0 is derived?
What is the direction of current flow in ct secondary...means if the current is flowing from P1 to P2 then what will be the direction of current flow in ct secondaryw
