Interested to Buy Any Domain ? << Click Here >> for more details...
What is the acceptable earth resistance for Commissioning
the Transformer?
- 6 Answers
- 10844 Views
- HSL, I also Faced
- E-Mail Answers
Answer Posted / deepak mishra
as per IS it should be less than 5Ohm
| Is This Answer Correct ? | 1 Yes | 1 No |
Post New Answer View All Answers
Is it required to lay GI wires along with GI/MS conduits from one point to another point though separate earthing cable is conncted from DB to Socket?
what do you mean by every IC 74 first digit.why are you using this no.why not using another no.
Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?
Please explain the following and how these are working with PLC unit 1.I/O Module 2.I/O Device 3.Adaptor Card 4.Ribbon Adaptor 5.RS 485-FC
How convergengr of nr method is not dependent on selection of slack bus and how gauss siedel method depends?
What will be the impact on motor performance if a LT motor is rewound with changed motor winding data as given below:- Original winding data: total 04 wires = 02 wires of 17 SWG + 02 wires of 16.5 SWG. Changed Winding data: total 03 wires of 15.5 SWG wire size Motor rating: 160KW, 740RPM, 415V, ID FAN application. Normal Running Current = 95% of FL Current.
Please sent me some previous year question papers of BSNL-JTO telecom and RRB in ELectrical Engineering to varshashahi@yahoo.com
what are your career plans upon completion of the programme and the relevance of recity generation to your professional development?
please give some hindalco placement papers for written exam
i will applied in 1U-1W on 440 volt primary delta side. what is the result of magtic balance test
State the formula for overall efficiency of thermal power station
On what cycle does thermal power plant operate?
What is the difference between relays and contactor construction wise?
two phases with neutral supply can be taken in 3C X 10 sq.mm cable .
Explain what is clipper and clamper circuits?
