Interested to Buy Any Domain ? << Click Here >> for more details...
we have consol make 3 phase servo stabilizer for cnc m/c.
while installing the earth neutral voltage is 1.7 volts at
stbilizer off condition and when stabilizer get on en
voltage reaches 4.8 volts (new earthing is done and neutral
is helthy condition all phase to neutral volts 440,442,441
v)why this happen.solution for cause.
- 3 Answers
- 7222 Views
- I also Faced
- E-Mail Answers
Answer Posted / pankaj mangukiya
plz check your multimeter. it may be because of corrupted
meter. OR while u measure the voltage keep it away from
Electrical area.
| Is This Answer Correct ? | 0 Yes | 1 No |
Post New Answer View All Answers
What is vacuum circuit breaker.define with cause and where be use it device?
Why do not we prefer non conventional sources of energy to conventional sources?
how can i determine the gear ratio for a rack and pinion system if an electronic gate operated by an electric motor is to travel a distance of 5meters in 15 seconds.
How would you calculate power loss in a resistor?
which connection is safer series or parallel?usually which connection we prefer at home?
State superposition theorem?
What is the height of DA, DAL, DB, DC & DDE tower?
What is the tipical Online UPS input voltage for 20 KVA load ( 3 Phase or 1 Phase )? Why ? Explain it...?
Initially, when the input is not equal to the output — what type of response is this?
Hi guys! Plz help me to answer the following questions. 1. What are the types of transmission line energy losses? 2. Why are the VLF are used some types of services? 3. What frequencies are used for reliable beyond the horizon terrestrial communication without repeaters? 4. To permit selection of 1 out 16 equi-probable, what is the number of bitis required? 5. What is the most common modulation used for telegraphy? 6. What is the multiplexing is used to increase the capacity of the optic fiber? Thanks
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
I am getting above 60 V as open delta voltage against single phase unit ICT at tertiary delta formed and ICT getting trippped on NDR. ICT tested and found in order. PTs provided on tertiary are tested and in order. what may be the reason?
1600 KVA ka transformer hi aghar lt side par 800A aur voltage 420 ho to HT side ki cable ki rating keya ho gi?
we use 400/5A ct and 35/roor3KV,/0.1/root3KV,0.1/root3KV pt ratio. What is the multiple factor of this meter.
state basic meaning of 'INDUSTIAL AUTOMATION'?
