Interested to Buy Any Domain ? << Click Here >> for more details...
WHAT IS THE DIFFERENCE BETWEEN PLC AND DCS
- 55 Answers
- 129107 Views
- ABB, Adani, Adani Power, GMR, IIUC, I also Faced
- E-Mail Answers
Answer Posted / anitha
plc is a progrramable logic controllers & dcs is a
distributed control systems.In brief PLC is product
controller.DCS is process controller.
| Is This Answer Correct ? | 0 Yes | 0 No |
Post New Answer View All Answers
installation process of orifice,a question asked for confusion creation in interview by BARC 1.if orifice is tightly fitted with pipe ,it will act like venturi 2.if orifice is left hanging in between liquid it will not create the pressure difference exactly,
How we connect a instrument with ground, Give brief explanation with help of diagram?
OBJECTIVE TYPE QUESTIONS OF ANALYTICAL INSTRUMENTATION
what is the difference between profibus and controlnet networking.
you are on site,the plant trips,you are approached by operations,what do you do?
how to calculate signal cable sizing? and multipair cable sizing??explain in brief?
hii my name is sujith...i am preparing for HPVL GET 2010... so ,,,pls help me by send any previous questions or material to my site.....(Msujith_12@in.com) thank q
dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,
What is ultrasonic flowmeter?
I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .
What is Erosion in a control valve?
please send data bank of quetions answers on analytical instrumentation.
which type of filter gives the constant phase characteristics?
in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?
In power plant to measure vibration of a turbine we install sensors. Before install this sensor we have to set gap voltage. What is meant by gap voltage and its use?
