How conduct the hydro & pnumatic tests of Pressure vessels
as per ASME & as per EN Standerds.
- 3 Answers
- 8341 Views
- I also Faced
- E-Mail Answers
Answer Posted / peds-phil
For Hydrotesting, test pressure is equivalent to 1.5 times
the vessel design operating pressure while pneumatic is
only 1.2.
| Is This Answer Correct ? | 6 Yes | 3 No |
Post New Answer View All Answers
Can some one please show me the design of a POT Bearing.
Why the centrifugal pump is called high discharge pump?
how buoyancy force is realte with convection?
if the blade height is increased,then how it increases the specific speed of centrifugal pump?
What is isometric drawing?
Why should a chain drive be used over a belt or rope driven drive?
can any one pls refer me any sites which have notes regarding Body-in-white(welding fixtures)...pls
Explain working of a fourneyron turbine?
Hello Friends I had my ONGC test today,but it was very bad.But I would give certain suggestions so that u may not face he problem which i had. Be thorough with Electrical Technology.Generators.motors stators etc.There are 5 questions on that. There were also good no.of questions from Hydraulic machine and Production technology. Then 3 from Strength of materials.And remember the dimensional quantities.
What is usage of rotameter and hydrometer.
have a clutchless car or bike clutch for power transmission???
i am appearing for the interview of the company SANDVIK??so if u can send me some questions or suggestions on how to prepare,it would be of great help to me.u can send the above at ekjain@yahoo.co.in.thanking you.
Is a diesel engines maximum rpm limited by the diesel burn rate?
hi friends kumar here if anybody of u have essar placement papers than plz send it to me i need it urgently..ok mail id is kskalyani@gmail.com
which type of material is F125?
