Interested to Buy Any Domain ? << Click Here >> for more details...
how to improve IR value in HT motors?
- 3 Answers
- 17559 Views
- ABB, AMW, Macleods, I also Faced
- E-Mail Answers
Answer Posted / prem
insulation resistance is measured using megger.if megger shows
meaurable value in tens or hundereds then just change the insulatin of lt motor to improve it.
| Is This Answer Correct ? | 7 Yes | 4 No |
Post New Answer View All Answers
How phase displacement change in the over current relay coils.
why we take movement of rotor always in counter-clockwise direction in 3-phase induction motors?
3 phase Motor will be given 2 phase after 2 to 5 second we given 3rd phase so Motor Run sum-time in forward or sum time run reverse direction. All time phase sequence is not change. Why motor run in reverse direction? Please Explain........
The screw thread commonly used for transmission of motion is one of the following types of threads
The Howland current source produces a A Unidirectional floating load current B Bidirectional single-ended load current C Unidirectional single-ended load current D Bidirectional floating load current
What do you mean by power transformer?
What is difference between unity power factor wattmeter and upper power factor wattmeter? In short circuit test of transformer the wattmeter used is unity power factor type or upper power factor type wattmeter?
i need list of swg(standard wire guage) or area of conductor v/s current carrying capacity of conductor copper & alluminium...
HOW TO CALCULATE THE VT SIZING?
Differentiate between low pass, high pass and band pass filter?
how can we change the polarity of Alternating current rapidly? how frequency of ac can be controlled and changed easily?
Salient pole alternator is more stable, why?
How to calculate the volumetric capacity of a oxygen & Nitrogen gas Cylinder if pressure is 145 kg/cm2 & water capacity of cylinder is 67 liters.
HOW TO DESIGN THE body EARTH cable(Copper Conductor) size for 60KVA UPS?
For refrigerators the motor current is raised beyond its rating on both conditions when the voltage of the system is more(say 270v) than the rated voltage(220v) as well as when the voltage of system is less(say 160v) than normal voltageof 220v, why explain?
