Answer Posted / arijit sen
Ohm's law is applicable for both ac & dc. But in case of ac ckt it is complicated.
| Is This Answer Correct ? | 18 Yes | 3 No |
Post New Answer View All Answers
What are different types of control systems?
Dear sir, I completed DECE In the year 1995.Now i am working in a private company from last 10 years as an Electrical supervisor.The company having a 1000 KVA transformer.Now i try to apply "C" Licence. I am eligible or not.If not eligible,pls give solution.
How to set the relay,,??
How many lightning arrestors to be installed on 50MX60MX10M building and is there any formular for that?
hi, i finished b.tech eee in 2008, im worked in dg sets mfg company , now i left job in 6months back, now again i want get job core side, how can i get? is there any couses we have learn to get better oppurtunity? /
what will happen if frequency is below 50 hz?
what are the difference between PLC and embedded
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
Is there a standard depth of gravel fill in Substation Switchyard? Please give a design/drawing. Thank you.
working principle of AC Servo Motor with its construction
How earthing of switchgear system to be done.
How to calculate cable rating for 3 phase supply?
State kirchoff current law?
In a power conditoining unit (inverter) of a solar plant when we measure the d.c. current fed by different strings of solar plates to inverter, the current in the negative wire is less almost by 1 ampere to the current in its positive wire say current in positive wire 5 A , then current in negative wire of the same string is 4 A. Since the current entering should be equal to current leaving then why the current is noticably less in negative wire.
anyone please send transformer parameter design formulas & details of tap changer ? plz i have interview this week its more helpful for me ?
