Interested to Buy Any Domain ? << Click Here >> for more details...
What is the difference between bushing and insulators.?
what is the creepage distance?
- 4 Answers
- 40562 Views
- I also Faced
- E-Mail Answers
Answer Posted / avd
Bushing : It has two parts 1. A hollow insulator may be
filled with oil or air depending on type 2. A conducting
stud or bus bar. Bushing is used to take out/in the power
from a machine without touching the ground parts.
Insulator : It is solid insulated material to isolate one
end (Live) to other end (Ground).
Creepage distance : Just imagine you have one insulator. An
ant starts from one end of insulator to the other end of
insulator. It has to travell on surface of petticoats also.
Distance travelled by ant is the creepage distance.
Hope this will clear your query.
| Is This Answer Correct ? | 41 Yes | 5 No |
Post New Answer View All Answers
what is the importance of Partial Dischage test for Electrical Equipments
distribution is maximum done by a)radial b)network c) parallel d)b & c
how to deside the capacity of chock for drive?
how indusrial diesel generator work
what is the minimum requirement gigaohms for the insulation test using 5kv in 300mm xlpe cable
if there is nutral in phase why we use earthing wire and grounding? even at fault condition the fault current flows to neutral (it is a lower path)
IN electrical field, WHAT ALL THINGS THE CUSTOMER WILL ASK WHILE ORDERING FOR LT PANEL (ALL TYPES OF LOW TENSION PANEL)
If 100 KAV USP dedicated earth got disconnect / Cut. What will happen at load.
how a resistor resists to flow the current?how an inductor oppses the sudden change in current?how a capacitor opposes a DC voltage.
1.how many types of relays? 2.difference between ATS& STS?
Is the installation of the filter cloths necessary before spreading the gravels at the transformer yards?
ACCORDING TO IEC WHAT SHOULD BE THE MINIMUM HEIGHT OF G.I. STRUCTURE OF CT, PT, ISOLATOR, LA?
What is the difference between Generator Differential Relay and Transformer Differential Relay?
What is the working principle of MIG welding? and its out put Voltage?
How can we findout the maximum efficiancy of Transformer? At which load?
