Golgappa.net | Golgappa.org | BagIndia.net | BodyIndia.Com | CabIndia.net | CarsBikes.net | CarsBikes.org | CashIndia.net | ConsumerIndia.net | CookingIndia.net | DataIndia.net | DealIndia.net | EmailIndia.net | FirstTablet.com | FirstTourist.com | ForsaleIndia.net | IndiaBody.Com | IndiaCab.net | IndiaCash.net | IndiaModel.net | KidForum.net | OfficeIndia.net | PaysIndia.com | RestaurantIndia.net | RestaurantsIndia.net | SaleForum.net | SellForum.net | SoldIndia.com | StarIndia.net | TomatoCab.com | TomatoCabs.com | TownIndia.com
Interested to Buy Any Domain ? << Click Here >> for more details...

I have a MRE200 amplifier for controlling a mitsubishi
servo motor, I would like to know how many pulses are
required to rotate the servo motor by 1 degree and what
must be the pulse width

Answer Posted / kuber

for this we need the no. of poles for the servo motor. then
speed of the servo motor = 120f/p
then cycles required for one rpm f = p/120
then we can derve the cycles for 1 degree revolution

Is This Answer Correct ?    1 Yes 1 No



Post New Answer       View All Answers


Please Help Members By Posting Answers For Below Questions

dear friends, i have seen flow as the selection critriea in presure guage (bourdon tube) and i would like to know what is the relation between flow and performance of pressure guage other parameters i found in the data sheet are pressure max. 1ksc temperature max. - 50 deg c line size - 80NB operating range - 1ksc pr. guage range - 0-2 ksc thank u,

2127


what is the PC interface and software for connection to ABB logic module “ LM011-CE18RAC “ ( for Programming ) ??

3951


plz send me general of ongc

1889


principle of dead weight tester ?

2004


What is the basic difference between Modbus and CAN Open Protocols

6384


What is furnace draft control?

1026


for oil & gas industries which zone is normally preferred? why? give its example?

1938


In a gas over oil actuator, after the opening/closing of valve, how the gas is vented out? How does the hydraulic/gas circuit function?

1773


why we use impulse line of flow transmitter at 45 deg. angle both side of orifice plate.

2332


What is force balance principle? State some of its’ advantages.

1115


why we should maintain neutral earth voltage below 1V while calibration? why cant it be 1.2V or 2V

2386


Isometric drawings are generated during _________________ phase of a project

2031


is there any digitel grevity meter availaible in the market by which we can measure specific gravity of a battery?

2166


Q- Control problem are mainly classified in _____ types. a-)4 b-)3 c-)6 d-)nono of these Few of them i know is 1- regulator type problem (eg- Air conditioner) 2- tracking problem (eg missile trcking problem) 3- sybernatics 4- optimal control problem

2078


Question on maha cement

700