Interested to Buy Any Domain ? << Click Here >> for more details...
why is the earthing pin on 3 pin top are big and thick
- 3 Answers
- 7014 Views
- Marriott, I also Faced
- E-Mail Answers
Answer Posted / ganesan
2 TIMES CURRENT DISCHARGE IN EARTHING PIN.BCOZ LOAD DEADTH
SHORT FAILURE OPERATION condition
| Is This Answer Correct ? | 1 Yes | 5 No |
Post New Answer View All Answers
how many single tension hardware are required on a double circuit transmission tower?
In a voltage-controlled current source A A current booster is never used B The load is always floated C A stiff current source drives the load D The load current equals Isc
How phase displacement change in the over current relay coils.
What is minimum phase system?
10 tube light connect in mcb breaker.one tube light is fault.so breaker is tribe.how fault is rectified.(using 3wire phase,earth,neutral)
What is the comparison between 30mA DP RCCB and 100mA DP RCCB and can replace it against 63A MCB
why the India electrical supply transmission loss is high when compare to us
What do you mean by ratio correction factor of instrument transformer?
33kv Rated output avilable in market (any where in india)
How servo stabilizer works.
what are the interview question asked in wind mill about electrical
How many wall/floor flange will i use in bus duct system if we have in our design a 35th floor building.
A Generator is in running condition and Rotor earth fault alarm is coming.How to check on line(i.e in running condition) whether there is actual earth fault in rotor or not.
to hook up ten 50 amp rv pedastels at a lenth of 600 feet from the service what size will my service need to be and the size of wire will I have to run to each pedastel in series??????
71ohm,111ohm,95ohm,179ohm in calculate the total ohm in series circuit
