Which OSI Reference Layer controls application to application
communication?
A.) Datalink
B.) Network
C.) Transport
D.) Session
E.) Physical
Answer Posted / sudharshan
E
| Is This Answer Correct ? | 3 Yes | 9 No |
Post New Answer View All Answers
What route entry will be assigned to dead or invalid route in case of RIP?
What is the size of hello packets in eigrep protocol?
What is a switch and why we are using switches?
Define network congestion?
If line down and protocol also down; in this case which layer move problem?
Can you explain PAP?
Suppose we have some switch in network and we are running RSTP how much convergence time will be there if one link down
Which protocol can do load balancing on unequal cost also?
On which bas ospf take decision?
What is difference between flsm and vlsm?
Mention what are the ranges for the private ips?
What is the command use to add a banner to a cisco router configuration?
Which command we use for ping in ipv6?
GUYS i was refraining the OLD post and i got a good Question and wana make sure that you guys Just did not vist it for answers if you are not Aware google it understand it and then answered it the question is -: Significance of IP helper-address Command on SW? Is it necessary to put this command? you donot wana to give answer please donot visit this question and increase the vistor name if you are thinking that answer is wrong mark it wrong and explain why you are marking it wrong
What is poe (power over ethernet)?