Interested to Buy Any Domain ? << Click Here >> for more details...
Answer Posted / ashish dubey
Slump is an arbitrary measure of workability.fresh concrete
filled in slump cone subsides when cone is taken up.this
subsidence of concrete measured and recorded as
slump.however same slump can be obtained for different
workability of concrete.day to day check on site.too high
and too low slump gives immediate warning.
| Is This Answer Correct ? | 9 Yes | 0 No |
Post New Answer View All Answers
What is thumb rule in quantity and cost estimation of a residential building in civil engineering??
1. HOW MUCH CEMENT AND SAND REQUIRED TO PLASTER 100 SQM WALL. 2. HOW MUCH CEMENT AND SAND REQUIRED FOR SCREED WORK OF AREA 30 SQM
What is a tensile strength? What is the tensile strength of wood?
A doubly reinforced concrete beam is 25 cm wide and 50cm deep to the centre of tension reinforcement. The centre of compression is steel is 5cm from the compression edge. The areas of the compression and the tension steel are 10.16cm2 and 12.56 cm2 if m=18 and the bending moment at the section is 7,000,000 N-cm. Calculate the stress in concrete and steel.
What are the different types of foundation?
on what basis the partial factor of safety are decided? form the load combinations
How many days should curing of plastering, brick work and concrete
what is box type waterproofing and how it is exsiccated and what is the method of doing box type waterproofing
What are the RISKS during the project construction?
I used Etabs software to analyse a high-rise building. And I want to use templated UBC-codes inside to calculate the Seismic load. My question is: whether or not I have to control the seismic load by base shear load which is manual calculation? (just for more clarification: I can control this by input the scale factor into Eartquake definition in Etabs) I would highly appreciate your answer.
What are moment of inertia and its importance in civil engineering?
What is soil enforcement?
Explain the Strength of brick?
Why Is Propping Required For Long Structures Once The Form Work Is Removed?
Reinforcement details at hinged joint
