Interested to Buy Any Domain ? << Click Here >> for more details...
What is an analog input - output , digital input - output .
Any example ???? How they r known its ai-ao or di - do
- 4 Answers
- 35887 Views
- Torrent Pharma, I also Faced
- E-Mail Answers
Answer Posted / barok
AI- means input of 4-20mA comes from transmitter to DCS
AO- means output of 4-20mA comes from the controller on DCS
DI- means input of 0 and 1 comes from switch to DCS
DO- means output of 24VDC come from DCS going to solenoid.
| Is This Answer Correct ? | 47 Yes | 8 No |
Post New Answer View All Answers
What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?
can any send me a forbes marshall dtron 316 manual
why we are using drum level control valve air to close?
How oil line flow measured?eplain about instruments used and working principle?
how can i calibrate the temperatuture gauge used by temperature bath(dry block) i mean step by step procedure?
Introduce yourself which is not present in your biodata?
What is compensation for flow ? Why we use compensation ? What are the factors of different compensation ? We not use then what problems may happen ?
how many maximum enter 2mm Dia solid cylindrical pipe into 8mm Dia hollow cylindrical pipe. give answer with calculation.
Define the terms Accuracy, precission, Spam, process tolerance while doing calibration of an instrument? Explaini with an example?
3. Differentiate between ultrasonic flowmeter and radar type flow meter.
How RAL(Rotary air lock)works in cement industry?
How can i test procedure grounding for CAT-7 cable? Or How can we test procedure CAT-7 Cable Electrically safe?
i have been asked by QAFCO to appear for interview for thy post of Instrument Designer(INTOOLS)..i m engineering graduate with 5 years exp. in design engineering.Will this job profile suit me??i need all ur help n suggestions for thy same?
how to do dynolab wind speed sensor loop test, how to simulate value,i have simulate mA 4-20mA but not responding in DCS faceplate, please kindly advice me any one.
I am having a Phoenix digital to modbus converter. The o/p of the same is connected to flow computer FB407. But the digital signals are updated only after one minute in the flow computer. what may be the cause of delay in communication? Flow computer is having a scanning period of less than 1 sec.
